|
» Generated Results for heat exchanger
The exchanger of heat heats or cools the corrosive fluids
5/3/02 heat exchanger posting
the exchangers of steel-tubed heat inoxidables of 730 series are available in 16 models with and without ventilators and joined guards of finger. The various piping and all circuits are built with stainless steel 316L which is mechanically stuck on the laminated and wrinkled copper ailerons. The sights are aluminium manufactured with the completion of gold irridite. The exchangers of heat receive the internal treatment of cleaning with glares acid, alkalins and deionized water.
The exchangers of heat maintain fences not insulated fresh
1/2/02 heat exchanger posting
the regenerating exchangers of heat of turbopump and weld-dish CLIMET-HE-200 of CLIMET-HE. operate from 380-460 and 200-240 VCA, respectively. The heat capacity of 44kW handles all the guns of plasma. CLIMET-RC. The refrigerated refrigerator functions out of tandem with CLIMET-HE, providing water alarming to the exchanger of fresh heat to up to 98 l/min and at temperatures as low as 7.C. CLIMET-RC-HV., evaluated with 16.4 kilowatts, hermetically sealed the compressor of Maneurop and the pump and the paddle wheel of stainless steel.
The exchangers of heat come with 90 curves
7/15/02 heat exchanger posting
model Water-with-Air KNHE30 delivers the uniform, cooling in closed loop for applications with conditions above what the air-to-air models can provide. Measuring 30 X 12 Po of the capacity up to 74 W/.F, the unit comes in 115 and 230 V It adapted with the hard environments where fresh, clean water is available. Model KNHE30 includes the motorized system of paddle wheel, support of M/TAB, and 6 pi of cord of sector.
The exchanger of heat the Air-to-air one ensures the environmental protection
9/13/04 heat exchanger posting
the models of AlfaChill include 3 welded exchangers of heat parcircuit (model AC10, AC20, and AC50), and 1 duel-A circuity the unit (model) AC80. The units offer the low volume of holdup and the capacity of cooling of 0.3.23 ton refrigeration. Able being employed for functions of refrigeration, all the models have the approval of the EC or UL.
Flexible fluids of handes of exchanger of heat with particulate substances
3/19/03 heat exchanger posting
the cold heat pump of climate provides the continuous heating downwards and below behind 0.. It employs the multiple stages of the heating by Bristol. TOTAL SOLIDS compressor, compressor of engine, and saver. These components, with the ordering of Johnson Metasys, answer the conditions of interior and external of air for the heating and the seasons of cooling. The coefficient of the execution is 2.7 with 17.F and 2.0 with 0.F. available in models of 2.5, 3.5, 4.0, and 5.0 tons, pump uses the cooling agent EPA-approval of R-410A.
The ordering of exchanger of heat maintains the temperatures of support
11/26/01 heat exchanger posting
Available for the new ones or existing water-heaters to the house, ambient healthy E-Technology R106K-5 extracts heat from lower quality starting from the ambient air, improves him, then transfers it because energy to heat water to the air 130.F. passing by the unit is cooled and dehumidified and can be employed to cool basements, garages, and workshops. Sprinkle the units heater-rises require the place of interior with 1.000 pi of minimum space, with proportioned ventilation, and ambient temperature of 46 with 110.F.
The exchangers of heat are pressure examined with 150 pounds per square inch
2/4/03 heat exchanger posting
the heat pump of SH10B offers the capacity of cooling of 2.5 tons and up to 7.00 HSPF. The compressor conforms of roller of Copeland isolated the box for the healthy order and the vertical discharge from air. The unit has the serpentine of evaporator with the antimicrobic coating, the lubricated engines in a permanent way, and the galvanized low steel rails. All adjustable times and temperature of device of models de-ice orders and 4 and models 5-tone are convertible with the downshot for applications of top of roof.
Lock of exchangers of heat of dish together for the tight joint
12/21/01 heat exchanger posting
Adapted to cool and heat various materials or surfaces punts, pumps of series of MPA incorporate the exchangers of heat built with the technology of aileron stuck by aluminium to high density and the aluminium base plates. The capacities of cooling extend from 20 to 70+ W, and the possibilities of heating are evaluated with more than 150 that W Pumps are appropriate for the dishes of hot/cold, cooling and the spot heating, and orders liquid temperature of container. The versions at high temperatures (+200.C) are available.
The exchanger of heat is appropriate for applications of gas and fluid of precision
3/26/02 heat exchanger posting
the cooling temperatures of pressure of principal direction controllers and modulate the speed of ventilator of condenser to balance high with the low vapor side pressure of circuit. On start to the top, the ventilator is given the initial hard beginning at the full speed during 10 seconds and then slows down at the speed at the temperature of condensation required by elasticity. While the ambient temperatures further fall, the ventilator slows down gradually to approximately 1/3 full speed to maintain the lubrication of bearing and can be given to zero on any desired level.
The exchanger of heat cools the electric stunt boxes
10/31/02 heat exchanger posting
Adapted with the residential or light commercial buildings, autonomous model RDX42.22U offer the posting of liquid crystal display of the temperature or the setpoint in F or the switch of C fan allows the continuous ventilator top or the automatic operation of ventilator, whereas the switch of system allows the manual choice of the heating, cooling, or in addition to position. The unit can be employed in the applications requiring 24 2 rollings up of ventilator of pipes fresh and 4 of stage of the stage heat/1 of VCA, unit air handling the units and the heat pump or the equipment based by compressor.
The exchangers of heat are ideal for applications of liquid-with-air
12/11/01 heat exchanger posting
Put in scene heaters to prevent the temperature coefficient of uses of overload of circuit, series of ZC and the positive bimetal disc to launch the action of commutation. The contacts are closed after range indicated of time. The ptc is art of the limiting car-portrait-current, ensuring the stable action of commutation on the range of tension. Comprising construction with semiconductors, the shock and vibration-resistant product have the range of operating temperature of -50 with +165.F and the estimate of contact of 12.5.25 A.
The exchangers of heat and the refrigerators have the nonferrous circuits of water
5/30/02 heat exchanger posting
Adapted to the applications using the heat pumps of source of water, of the coolers of series of HW are conceived with the copper construction of rolling up for the effective thermal transfer. The units the system of distribution incorporate the ventilator of outline, construction 1-part, and water obligatory centrifugal ahead curved of Hydrospray., which provides the rolling up of surplus of model of jet 360. for conformed, even jet. Available in 10 model configurations, capacities you of 10.200 tons nominal extend.
The exchanger of heat comprises the estimate of the NEMA 4/4X.
11/24/04 heat exchanger posting
Comprising INCOLOY engainé, the resistive type elements of heating, the hot water of series of BH or the electric steam boilers are the compact units, completely packed and of cable with automatic checks. They are available with entries of 60.3.000 kilowatts and exits of nominal of 196.000.9.800.000 BTUH. The water-heaters are of 150 psig MAWP, and the steam boilers can be 15 or 150 psig. Each electric hairpin of element is with replaceable field without requiring the welding, welding, or to weld it.
Welded exchangers of heat are offered in two types
1/29/03 heat exchanger posting
the induced products duels of outline FXV of air intake use the packages duels of rolling up and wet surfaces of thermal transfer of platform on a common system of ventilator. Cells can be multiplexed coast at coast, and the thermal execution is independently certified by cooling the institute of technology. The design incorporates the combined technology of flow, which joint the exchanger of heat and the tower of cooling in a unit. The fluid of process to be cooled is maintained clean in the contaminant-free blocked loop.
|
|
|
|
» Related categories
» Information Sources
» User comments * BETA *
The piece was both interesting and informative. It is clear that you researched thoroughly and presented the information in a concise manner.
I was doing a bit of surfing the other day and came across an interesting page you threw together earlier I think.
I've been meaning to tell ya.... The page is excellent! I check it out every day. Thanks for the great material
|
|
